Friday, November 20, 2026

On its feet again - Marchant XL

The mid 1920s Marchant XL that didn't look so bad (but was), now actually is ok; it works and it's on its feet again.


About those feet: the very early Marchant XL (and K) machines have the large rubber pads with a cross, similar to the feet that are nailed under the boards of the predecessor Pony machines. This specimen however had round pads on a metal disk - a bit smaller in diameter and less tall than the original rubber feet - as if a 1930s Odhner pad (but in red rubber) was bolted to a disk. It looked likely a later replacement/repair.

Looking at several XL machines that are visible online, several also seem to have similar smaller, shallower feet. Coupled with the special dished holding cup, this may even have been a later foot-design adopted by Marchant. (After around serial number 93,500 ?)


The new construction -if it is that- seems not cheaper than the large-cross pads. It has a surprising number of parts. If not for several more machines seen online with the same style of feet, I'd have concluded for certain that these were a later 'make-do' replacement. Now, simply unsure.


The rubber pad is fastened to the metal disk with a screw, nut and one dished 'washer'. This must be done before it is mounted onto the machine with two screws. These screws are covered by the pad, so this has to be bent up to get at the screws. That'd have been fine when new, but after 97 years the rubber can be brittle an dnot flex so readily.

To keep the character of the machine, similar pads were made and fitted with the original hardware. Later repair or original design, decided to keep this and reproduce. New rubber pads were manufacured - and mounted on the original disks with screw, nut and cup. The disks then mounted on the machine base. Did not take the effort to source red material, so black all-through will have to do :)


They seem 'small' for the pedestals of the base casting, but are pretty much identical in size to what was on the machine - in any case they make the XL safe to place on a table again.

The one remaining functional detail of the XL - the overflow bell - was indeed an easy fix.


The long, thin spring wire must rest against the back of the base. The bell clapper 'ball' is mounted on a relatively soft steel wire. This needed to be bent back into shape to almost touch the bell in rest position. The machine now loudly signals an overflow or underflow again - when turned smartly, that is. 

Because it is actuated by a push from the carry-levers and not a trip, it only works reliable when the crank is turned smartly. About half a second per turn (or faster) to make it 'ding!'.


The brass plaque did say speed!

In restoring this XL, the approach was to remove signs of mis-use, but keep signs of use. Ergo it was mainly cleaned with excessive rust removed, but for example the paint loss on the aluminum sidewall was left alone. Normal handling would indeed cause the paint to be worn/flaked away in those spots.

Even though the greyhound plaque suggests something fast, speed-wise the XL is not different from any other manual calculator. Granted, it does work simply and accurately (like nearly all other calculators of the period). In the XL the tens-carry in the counter is of course a useful improvement on the predecessor Pony-range.

Anyways - it works! With 5 turns of the handle and one carriage-move; 20.48 times 0.32 equals 6.5536:

No comments:

Post a Comment